I feel a casting session....

by **dhtaxi** » Thu Nov 19, 2009 2:11 pm

I gues I wont be able to afford it then. :bigsmile:

by **DuncaninFrance** » Fri Nov 20, 2009 3:47 am

joseyclosey wrote:
DuncaninFrance wrote:
dromia wrote:Price varies depending on how much I like you.

At the risk of being bankrupted, can you send me a bottle (?). PM me a total price and I will send a rubber check immediately

Duncan, i have some bits and pieces for you, i will liase with Adam about a winter relief package for you.

Joe

Cheers Joe, nice to know someone cares a little :roll:

I hope you guys are all above water at the moment, pics on BBC News24 do not look very good

by **dromia** » Fri Nov 20, 2009 1:27 pm

dhtaxi wrote:I gues I wont be able to afford it then.

Thats right Dave. :bigsmile:

by **joseyclosey** » Sat Nov 21, 2009 1:14 pm

DuncaninFrance wrote: Cheers Joe, nice to know someone cares a little I hope you guys are all above water at the moment, pics on BBC News24 do not look very good

We are ok in the North East Duncan, it was the North West that was under the cosh.

Joe

by **dhtaxi** » Sat Nov 21, 2009 1:20 pm

But it heading our way.

by **joseyclosey** » Sat Nov 21, 2009 1:31 pm

Back to the thread title....

Off to see my bestest, bestest pal in the whole wide, wide world tomorrow and it looks like we are going to be busy, i have a boot full of lead and these pretty little toys to play with.

Joe

by **dhtaxi** » Sat Nov 21, 2009 2:12 pm

Are you casting any 6.5x55 by any chance or perhaps some body would lend me a mould for just one week I mean you know just one week.

by **joseyclosey** » Sun Nov 22, 2009 3:27 pm

Only cast 8 mil and 303 but I will bring you some boolits to the castle on Thursday night Dave, or if you are really keen i have a spare mould you can borrow.

Joe

by **dhtaxi** » Sun Nov 22, 2009 6:52 pm

If you could lend me a mould preferably a 140grain for I week that would be great I will fire the furnace up crank them out and return it to you.
I have been looking at a Lyman 140 grain mould £60
Top punch £8
Sizing dies for the lubriser two in diferrent diameters £20 each so £40 in total.
Grand total£108, I would like to see how it performs with cast before I lay out £108 squids.

by **dromia** » Mon Nov 23, 2009 3:31 am

Now Dave I might just know here there is a Lyman 6.5 140 gn mould for sale at price lower than that.

Top punches, make your own with some epoxy in any punch you have, let it set on the boolit of your choice and there you go.

Sizing dies, I'm putting in an order soon for bespoke ones so what diameters do you want.

I feel a casting session....

Re: I feel a casting session....

Re: I feel a casting session....

Re: I feel a casting session....

Re: I feel a casting session....

Re: I feel a casting session....

Re: I feel a casting session....

Re: I feel a casting session....

Re: I feel a casting session....

Re: I feel a casting session....

Re: I feel a casting session....

Who is online