How to make a Splice Repair

Questions and tips about taking care of the weapons we collect and shoot.

Moderator: Aughnanure

User avatar
Candyman
Contributing Member
Posts: 192
Joined: Wed Nov 18, 2009 2:24 pm

How to make a Splice Repair

Postby Candyman » Thu Jul 01, 2010 8:54 am

Making Splice Repairs are not as hard as you would think. I have seen people replace some very nice stock just because it was missing a chip of wood
This post will walk you through a repair

As always, we need a Victim. For this post I will use a M1 Carbine.
This type of damage is very common on Carbine stocks. Most of the time it is caused by the improper fitting of the recoil plate.
Image

First you will need to mill out the damaged area. This can be done with a Dremel tool and a highspeed cutting bit or wood files. You will need to square up the damaged area so that a new piece of wood can be fitted.
Image

Then cut a pice of wood to fit the area. Try to match the wood as close as possible, this will help to blend the repair. Try and cut your replacement piece so that it fits sung and test fit it.
Image

I like to use Brownell's Acraglass for my repairs, but a clear epoxy like Devcon 2 Ton Epoxy with the 30 min. set time can be used. Do not use super glue, wood glues or any of the 5 min. epoxys, they will not hold up in the long run.
Once you have applied the resin, clamp the piece in place.
Image

Once the resin has cured, trim the pice of wood down close to where you need it with a dremel tool or file.
Image

Then dress it up using a sanding block and sand paper.
Image

The hardest part of a repair can be blending in the finish. Most offten I use alcohol base stains or dye to blend the finish.
Image

Image

Image
User avatar
kermit
Posts: 26
Joined: Mon Aug 27, 2012 11:38 am

Re: How to make a Splice Repair

Postby kermit » Mon Mar 11, 2013 10:21 am

extremely helpful post. thank you.

Return to “Upkeep, Repair and Restoration”

Who is online

Users browsing this forum: No registered users and 2 guests