Remington 597
Posted: Sat Oct 06, 2012 10:34 pm
Finally got around to installing a set of sling studs on my little 597. This was the first time I have put them on a synthetic stock. It wasn't too bad but my drill press saved the day when I had a break out removing half of a pillar on the inside of the fore end.
Followed these instructions: http://youtu.be/kOGt9S5nQDU If you watch the video you'll recognize the part where the drill press and 3/8" bit were needed.
It didn't take Sarah long to claim the rifle once the sling went on
Followed these instructions: http://youtu.be/kOGt9S5nQDU If you watch the video you'll recognize the part where the drill press and 3/8" bit were needed.
It didn't take Sarah long to claim the rifle once the sling went on