KINETIC BULLET PULLER FOR MARTINI-HENRY....

[DuncaninFrance]

...........and Snider ammunition.

"It is a 3/4” threaded PVC T junction, a 1” Cap, a 3/4” to 1/2” threaded bushing and a 1/2” threaded plug. You have to use a Dremel or file to open up the bushing to allow the case to pass through enough to use the plug—and even then sometimes a rubber mallet to free the case once the bullet has been released."

[Niner]

Did you make that yourself?

[DuncaninFrance]

No, not yet! It was posted on another site and I thought it looked like a good idea.
So does blackisler but he wants me to make one first so he doesn't have to spend any money on it if it doesn't work - typical Scot!!!!

[Aughnanure]

I have a similar one made out of old steel pipe fittings and it works like a charm.
I posted on here and carried out a mod at, I think, Niner's suggestion of putting in a gas escape hole just in case something went amiss; mightn't want one in plastics but you can't be too safe.

[Niner]

Just on the chance that someone is browsing this post and is new to the site, or it was so long ago they don't remember , here are a couple of alternatives including Eoin's post about his homemade puller:

https://milsurpafterhours.com/bb/viewto ... ler#p53022


https://milsurpafterhours.com/bb/viewto ... ler#p58273

[DuncaninFrance]

Well, went down to Mr.Bricolage this morning and had a play around this afternoon. Voila!

Have not tried it yet but will report back when I have...........

[DuncaninFrance]

Works a treat.............