Followed these instructions: http://youtu.be/kOGt9S5nQDU If you watch the video you'll recognize the part where the drill press and 3/8" bit were needed.
It didn't take Sarah long to claim the rifle once the sling went on
Remington 597
Moderator: blackisler
Remington 597
Finally got around to installing a set of sling studs on my little 597. This was the first time I have put them on a synthetic stock. It wasn't too bad but my drill press saved the day when I had a break out removing half of a pillar on the inside of the fore end.
Followed these instructions: http://youtu.be/kOGt9S5nQDU If you watch the video you'll recognize the part where the drill press and 3/8" bit were needed.
It didn't take Sarah long to claim the rifle once the sling went on
Followed these instructions: http://youtu.be/kOGt9S5nQDU If you watch the video you'll recognize the part where the drill press and 3/8" bit were needed.
It didn't take Sarah long to claim the rifle once the sling went on
Retired Systems Engineer
Full time Grandpa to
James 16
Angela 15
Khaley 5
Kendall 4
Loralai 2
Full time Grandpa to
James 16
Angela 15
Khaley 5
Kendall 4
Loralai 2
-
A square 10
- Leading Member
- Posts: 481
- Joined: Mon Nov 01, 2004 12:30 pm
Re: Remington 597
i dont blame her - it looks to be a nice setup ,