Milsurp After Hours

Now I am jealous. I want one of those but not allowed. Congrats on getting the rifle.
Regards
Peter.

Very cool rifle, that looks like it will be a lot of fun to shoot.....

.

Sorry Peter!

Would be nice to find some wood furniture for it that didn't cost a fortune

First 5 rounds - faultless!
And here is the video........... https://www.youtube.com/watch?v=5-omzkZ ... e=youtu.be

I love this so much!

I'm so happy that it's here. It's such a nice looking rifle too.

-ArchFluffy

Fun rifle.... except for the cycling part. Are you at the range or in your garage????

.

Shooting out of the barn Vern.
Our barn faces East and up a slight hill so I was able to put the rounds into wast ground before the vines.

Oh nice, wish I could shoot at my house..... but it would piss off the neighbors across the alley...

.

DuncaninFrance wrote: ↑Wed Feb 12, 2020 6:57 am Arrived today..........

Those magazines appear to be Metric pattern, not inch pattern. The positioning beak on the front of the magazine is metric.

That said, I have a FAL rifle that is all-inch pattern, except for the cut for the positioning beak in the magazine well, which is metric pattern.

It may work anyway.

Mag marked 1 came with the rifle and is an inch mag BUT it was restricted to 10 rounds by having a hole drilled in the back facing edge and a large pop rivet placed in it. As the mag was new i 'removed' the rivet and it is now a 20 round mag

Mags marked 2 are metric which I bought online. I converted the worst of the two to a 10 round mag by drilling a hole and putting a large rivet in place at the same height as the original that came with the rifle.
So I have a 10 round one to show with the rifle and 2 x 20 round ones to use at the range.

The only problem I seem to have - and until this lock down is over and the range is open again I can't tell - is that the rear sight moves forward up the ramp as I shoot. This is probably due to the recoil, non of which is used on the gas piston because it is a single shot rifle. I have removed the sight and checked it and it is in A1 condition. Spring and ball bearing are as new so I may need some Duck Tape to prevent the forward movement.