Milsurp After Hours

My cz52 locked up between ejecting rounds. I cleared it and the slide would jam when I pulled it back manually.It worked ok upside down.I took it apart and one of the roller locks fell out of the roller cam. Any ideas what to do? Get a new barrel? Where does one get the parts?

I think the rollers came out of mine before. I haven't shot it in a long while so don't really know what I did. But opened J.B. Woods Firearms Assembly/Disassembly guide and this came up as to the rollers. There is more to it than this. Just can't remember what my experience was.

Thankyou. It just sits in my safe for now till I figure out what to do. Having that bearing fall out is not good. I seem to have seem something somewhere about replacment bearing or something or other.

Try makarov.com

They are Mak and CZ52 specialists and have a ton of parts.

Thanks Karl, I checked it out and about all I could find was a 9mm. conver. barrel. or new rollers. The part that holds the rollers is what is the problem. The one just falls out or jams when fireing. Thanks again.