Milsurp After Hours

Bren combination tool, with all screwdrivers out

http://img.photobucket.com/albums/v174/ ... C00467.jpg[/pic]

.http://img.photobucket.com/albums/v174/ ... C00469.jpg[/pic]

http://img.photobucket.com/albums/v174/ ... C00470.jpg[/pic]

Anyone remember what all the bits fitted or did? Or would like to have a guess?

Eoin.

Eoin,

Is that tool missing a part?

I seem to remember a fairly thick tubular tool (about 1" i/d *) with a flattened and shaped end - the gas port adjuster tool - as part of the "combination tool" and stored in the wallet within the carrier for the second barrel group. - Is it possible that the piece you have was designed to fit inside this for storage?

Regards

Tom

*It's thirty years since i've seen one, so my memory may be a little off.

Tom,

No this is a complete tool, the gas adjusting bit is the bar directly behind the copper hammer. There are bits that I don't remember too. Maybe the bit you're thinking of was a cleaner for the hole that the gas selector(?) fitted into?

Eoin.

I just filched these from

www.canadiansoldiers.com/weapons/bren.htm

http://www.canadiansoldiers.com/weapons/brenwall.jpg[/pic]

http://www.canadiansoldiers.com/weapons/brenbag2.jpg[/pic]

Eoin.

I think it's tools used by shoe salesmen on Ro-dayo Drive?

IMHO:

Thanx Dante'