Page 1 of 1
Looking for bullet mould
Posted: Sat Mar 17, 2007 11:00 am
by DoubleD
I am looking for RCBS bullet mould 055015 590-520-M. This is the mould designed by Jim Goodwin for 577 Snider. I only want a bullet cast from this mould. I am going to send the bullet to Barry Darr to have a cherry made so he will have it on inventory for those who want a mould.
If you have this mould please contact me.
Posted: Sat Mar 17, 2007 12:49 pm
by dromia
David Minshalls yer man for this.
I'll email him.
I'll have one of these from Barry if we find one.
Posted: Sat Mar 17, 2007 12:54 pm
by dromia
Email sent to David.
Posted: Sat Mar 17, 2007 10:45 pm
by DoubleD
Bullets found from two sources, thanks guys!!
I'll keep you advised on the status of this project.
Posted: Sun Mar 18, 2007 1:44 pm
by DoubleD
Bad news Borton Darr doesn't make hollow base bullets and this Snider bullet is a hollow base bullet.
Good new Borton Darr are going to make the Jim Goodwin design Martini Bullets.
Contact them at:
BW Darr
724 Mill Run Road
Mill Run, PA 15464
Phone:724.455.5837
Posted: Sun Mar 18, 2007 2:31 pm
by DuncaninFrance
Go and check out
http://castboolits.gunloads.com/
It is a mine of help and information