Page 1 of 1
Has anyone seen this sight?
Posted: Sat Jul 05, 2008 1:12 pm
by Brass Rat
They say that it will work on a #4 if you ream the axis pin hole for the windage screw and drill a hole for the detent.
http://pic40.picturetrail.com/VOL368/95 ... 166426.jpg[/pic]
Posted: Sat Jul 05, 2008 2:08 pm
by krinko
Yes, with permanent modification to the receiver, it will work on a No4 Enfield.
-----krinko
Posted: Sat Jul 05, 2008 7:46 pm
by Woftam
As Krinko says it requires permanent modifications. Wouldn't put it on an unmodified rifle but on something bubba has already got at, that's a different thing.
Posted: Sat Jul 05, 2008 10:55 pm
by Brass Rat
I am trying to set one up for 3x600 match shooting.
Posted: Sat Jul 05, 2008 11:42 pm
by tarasbulba
Sarco in new jersey has been selling this sight for quite sometime. Frank
Posted: Sun Jul 06, 2008 12:02 am
by Brass Rat
Thats where I'm looking at it.
Rear Sight
Posted: Sun Jul 20, 2008 4:38 pm
by Will Durant
This sight showed up a few years ago and I reccomended then that the sight be sleeved with brass tubing from a hobby shop anduse the existing shaft.Do not modify the rifle work with the sight.Will
Posted: Fri Aug 01, 2008 6:14 pm
by Brass Rat
I thought about doing that but the original shaft is not threaded for windage adjustment
