CZ-52 jam

Warbds · Post by **Warbds** » Sun Oct 09, 2005 10:46 am

My cz52 locked up between ejecting rounds. I cleared it and the slide would jam when I pulled it back manually.It worked ok upside down.I took it apart and one of the roller locks fell out of the roller cam. Any ideas what to do? Get a new barrel? Where does one get the parts?

Post by **Niner** » Sun Oct 16, 2005 10:50 pm

I think the rollers came out of mine before. I haven't shot it in a long while so don't really know what I did. But opened J.B. Woods Firearms Assembly/Disassembly guide and this came up as to the rollers. There is more to it than this. Just can't remember what my experience was.

Warbds · Post by **Warbds** » Mon Oct 17, 2005 9:06 am

Thankyou. It just sits in my safe for now till I figure out what to do. Having that bearing fall out is not good. I seem to have seem something somewhere about replacment bearing or something or other.

Karl/Pa. · Post by **Karl/Pa.** » Mon Oct 17, 2005 2:57 pm

Try makarov.com

They are Mak and CZ52 specialists and have a ton of parts.

Warbds · Post by **Warbds** » Tue Oct 18, 2005 5:07 pm

Thanks Karl, I checked it out and about all I could find was a 9mm. conver. barrel. or new rollers. The part that holds the rollers is what is the problem. The one just falls out or jams when fireing. Thanks again.

CZ-52 jam

CZ-52 jam

Don't think you should need a new barrel